SETTING UP A LOCAL WIRED SERVER HOW TO
SETTING UP A LOCAL WIRED SERVER DRIVER

$ ip link show dev enp2s0 2: enp2s0: mtu 1500 qdisc pfifo_fast master br0 state DOWN mode DEFAULT qlen 1000 To check the status of the interface enp2s0: Network interfaces can be enabled or disabled using ip link set interface up|down, see ip-link(8).

SETTING UP A LOCAL WIRED SERVER DRIVER

See /Ethernet#Device driver or /Wireless#Device driver.Įnabling and disabling network interfaces If your network interface is not listed, make sure your device driver was loaded successfully. See also /Wireless#Get the name of the interface. Wireless device names can also be retrieved using iw dev. Note that lo is the virtual loopback interface and not used in making network connections. Listing network interfacesīoth wired and wireless interface names can be found via ls /sys/class/net or ip link. Tip: To change interface names, see #Change interface name and #Revert to traditional interface names. Plug in the Ethernet cable or connect to the wireless LAN.

Ensure your network interface is listed and enabled.

To set up a network connection, go through the following steps: You can run a traceroute to further diagnose the route to the host. If you receive an error message (see ping error indications) or no reply, this may be related to incomplete configuration, but also your default gateway or your Internet Service Provider (ISP). Note that computers can be configured not to respond to ICMP echo requests. For more information see the ping(8) manual. Ping is used to test if you can reach a host.

Check if you can resolve domain names (e.g.

9.9.9.9, which is a DNS server operated by the Quad9 Foundation and is a convenient address to test with).

You can ping a public IP address (e.g.

Your routing table is correctly set up.

Your network interface has an IP address.

The cable is plugged in or you are connected to the wireless LAN. Otherwise, check the device driver – see /Ethernet#Device driver or /Wireless#Device driver.

Your network interface is listed and enabled.

To troubleshoot a network connection, go through the following conditions and ensure that you meet them:

Medium-specifics are handled in the /Ethernet and /Wireless subpages.

SETTING UP A LOCAL WIRED SERVER HOW TO

This article describes how to configure network connections on OSI layer 3 and above.

Setting up a local wired server